Page 85 - Turner 1st sem Practicals

4. Place the wooden block which was used for dismount-
ing the chuck on the bed near the spindle nose.
5. Place the chuck on the wooden block.

6. Set the spindle at the lowest rpm.
7. Slide, rotate and mount the chuck on the spindle nose.
(Fig 14)
8. Fasten the chuck rigidly with the spindle using the
appropriate wrench supplied with lathe.
Note : Follow the same procedure for the
mounting and dismounting of driving plates.

Producltion & Manufacturing : Turner - Exercise 1.3.24 73