Page 55 - Turner 1st sem Practicals

The work must be properly gripped in the vice. If necessary, Stop chipping before the end of the surface; otherwise, the
support the work on the wooden block. (Fig 4) edge of the job will break off. (Fig 6)

While chipping look at the cutting edge of the chisel, and
not at the head of the chisel. (Fig 5)
To prevent this, chip the end of the job from the opposite
Position the chisel in such a way as to cut the metal in direction.
uniform thickness. (Fig 5)
Hold the hammer at the end of the handle for maximum
leverage. (Fig 7)

Producltion & Manufacturing : Turner - Exercise 1.2.14 43